If it is a "Line Out" signal level, you can probably get away without loading it with resistors. Ideally, you can solder appropriate resistors onto another 3.5mm jack, and plug that into the B output of the switch, and you're set. ![]() Plug the output cable that was plugged into your audio source into the A output of the switch. Plug the input into the common terminal with the patch cord, and plug the other end of the patch cord into the audio source. Get a 3.5mm patch cable and a 3.5mm A|B switch, and put it on your desk. While you do not like the various 3.5mm audio A | B switch units that you have seen, thus far, you should be placing proper function over some sort of stylistic preference that you will spend more time and money kludging-together, only to find that it will be a very poor performer. The power rating of those resistors should be equal to or greater than the maximum RMS power output of the audio generating device.Ģ.) The Pass and Seymore switch is designed for 120VAC operation, which likely means that the contact resistance of the closed switch will not be optimal for an audio output connection. You need at least a DPDT switch to achieve the independent switching of left and right channel conductors, and it would be advisable to use 2 - 16Ω to 32Ω resistors (one for left and one for right) to load the output from the computer / amplifier. The Pass and Seymore switch is wholly inappropriate for the use case being discussed.ġ.) It only contains a SPST switch. Volume Control for 3. Your link doesn't suggest that, but it doesn't look all that well made. Using your AB solution, would there be any problem with noise leaving the "B" side open? A lot of these switches, mixers, or "sharing switches" that I've found on amazon have 1 star ratings saying they are cheaply made with popping noises. Too often I forget these are hooked up and end up sending speaker noise into other parts of the house so it would be nice to be able to just shut them off with a button or switch and only connect them during the few times I need them.Īnyway, my plan is to always leave the Logitech 2.1s connected, but I'd like an easier way to disconnect the remote speakers besides just unplugging them. and its affiliated entities companies use cookies and similar technologies to perform essential online functions, such as authentication. These speakers just plug into any outlet and can receive the signal. My plan was to put a 3.5mm splitter into the onboard soundcard female port, then send one run to the logitech subwoofer and the other to a wireless speaker signal sender which then sends a signal out to some remote speakers (see link below). This cable then goes to the subwoofer which then sends it down stream to the Front Left and Front Right speakers. ![]() I have a basic 2.1 logitech speaker system (Z623) which has only one 3.5mm jack that plugs into onboard soundcard. It's provided 12-month warranty with hassle-free refund or a free replacement offered by Cubilux.I have no idea what any of that means. Built to Lastīuilt with full Aluminum housing for lasting quality. For instance, If you use TS mono cable for input, then you will need to use TS cables for output too(Similarly to TRS stereo cables). ![]() ![]() Please only use the same type of cables at one time. Independent switch design enable easy control to cut off or let in audio without plugging or unplugging the cables. (Please note: Due to the passive design, when connecting a couple of output please turn up the volume accordingly to achieve the appropriate effect.) Switch Control Superior Audio Qualityįeatures gold-plated jacks maintain the highest sonic quality with ultra low-noise. The MagSafe charging case includes a built-in speaker and Precision Finding so you never lose it. A must have for live performances, studio recording or podcasting. Audio with dynamic head tracking for immersive sound. Equipped with five 1/4" output connector jacks, this 1/4" audio splitter distributes a single audio feed in Mono/Stereo mode to up to 5 sources for powered speakers, amplifiers, monitors, headphones, etc.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |